RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: G T
Showing results 1 to 7 of 7
Search took 0.02 seconds.
Forum: Gas Engines
11-01-2016, 02:19 AM
Replies: 2,806
Views: 711,503
Posted By G T

Great job, good to hear a good news story...

Great job, good to hear a good news story in this tread. ��
Forum: Gas Engines
03-10-2016, 05:07 PM
Replies: 2,806
Views: 711,503
Posted By G T

--------------------------------------------------...

--------------------------------------------------------------------------------------------------------------------------------------------------
thanks Radfordc for your links with info, very...
Forum: Gas Engines
02-26-2016, 01:09 AM
Replies: 2,806
Views: 711,503
Posted By G T

i am using 96 octane - 20% oil mix with Mobil...

i am using 96 octane - 20% oil mix with Mobil synthetic 2T oil
this is the oil i have used in all my petrol motors.
East Coast Lubes - Mobil Oil Distributor, Synthetic Oils ......
Forum: Gas Engines
02-23-2016, 07:55 PM
Replies: 2,806
Views: 711,503
Posted By G T

Hi scubaozy on my low end i have that at 6 3/4...

Hi scubaozy
on my low end i have that at 6 3/4 turns out, it has a bit of a rich sounding burble when on idle , but the throttle response is great and it pulls 6000rpm with a 20x10 3 blade wooden...
Forum: Gas Engines
07-14-2015, 12:40 AM
Replies: 2,806
Views: 711,503
Posted By G T

Do any of you knowledgeable engine heads out...

Do any of you knowledgeable engine heads out there think this piston barrel cracking could be caused from a hydraulic lock. I cant see myself how oil could leak into the cylinder and cause it to...
Forum: Gas Engines
05-28-2015, 10:31 PM
Replies: 2,806
Views: 711,503
Posted By G T

I had to lean my carb settings to get it to run...

I had to lean my carb settings to get it to run OK ,, but i am in the tropics and all my motors are always leaned out to what is recommended to get them to run properly .
My FG60 is running very...
Forum: Gas Engines
03-30-2015, 12:50 AM
Replies: 2,806
Views: 711,503
Posted By G T

Hi all I have had the motor for a few weeks now...

Hi all
I have had the motor for a few weeks now and have run about 5Lts of fuel through it now, I have noticed that if you run it too rich on the high needle it will start to cut no 3 cylinder out...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.