RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: DarthFlyer
Showing results 1 to 10 of 10
Search took 0.01 seconds.
Forum: Gas Engines
04-27-2020, 08:18 AM
Replies: 2,806
Views: 711,706
Posted By DarthFlyer

what operating temp should cylinder be on an...

what operating temp should cylinder be on an Saito FG-60R3?
Forum: Gas Engines
04-27-2020, 08:15 AM
Replies: 2,806
Views: 711,706
Posted By DarthFlyer

What temp should the cylinders be on an Saito...

What temp should the cylinders be on an Saito FG-60R3?
Forum: Gas Engines
11-08-2016, 04:06 PM
Replies: 2,806
Views: 711,706
Posted By DarthFlyer

I have been using Redline to break-in my new...

I have been using Redline to break-in my new engine. Of course ran it rich as heck during the first three tanks. Even now after 2 gallons, I too see the black gunk all over the test stand. Since...
Forum: Gas Engines
11-05-2016, 01:33 PM
Replies: 2,806
Views: 711,706
Posted By DarthFlyer

Thanks so much for all the help! It is running...

Thanks so much for all the help! It is running great and meeting my expectations. Soon to go on my Giant Top Flite Corsair

video link
https://youtu.be/kwDvkEn3v1U
Forum: Gas Engines
11-05-2016, 08:52 AM
Replies: 2,806
Views: 711,706
Posted By DarthFlyer

Right about that, what about needle settings,...

Right about that, what about needle settings, anyone have thoughts on the settings from close? Both HS & LS?
Forum: Gas Engines
11-05-2016, 02:19 AM
Replies: 2,806
Views: 711,706
Posted By DarthFlyer

You were correct, I was facing the prop. Manual...

You were correct, I was facing the prop. Manual clearly states "Pilot's View" which is obviously behind the engine. I do have #3 and #2 reversed. Thanks so much for the help!!! Cannot believe I...
Forum: Gas Engines
11-05-2016, 01:50 AM
Replies: 2,806
Views: 711,706
Posted By DarthFlyer

About 4.5 turns out with the LS. What is the...

About 4.5 turns out with the LS. What is the default settings for both? could not find it in what Saito refers to a "manual"
Forum: Gas Engines
11-05-2016, 01:48 AM
Replies: 2,806
Views: 711,706
Posted By DarthFlyer

Will do, I have noticed cylinders #1 & #2 are...

Will do, I have noticed cylinders #1 & #2 are very warm, while #3 is cool even when running full throttle
Forum: Gas Engines
11-05-2016, 01:47 AM
Replies: 2,806
Views: 711,706
Posted By DarthFlyer

Thanks, checked again, appears to be as the...

Thanks, checked again, appears to be as the manual illustrates. Facing the prop, #3 lower left, #2 Lower Right, #1 top.
Forum: Gas Engines
11-03-2016, 05:02 PM
Replies: 2,806
Views: 711,706
Posted By DarthFlyer

I am have trouble getting over 5000 RPMs with my...

I am have trouble getting over 5000 RPMs with my FG60r3. Running proper fuel mix and so far ran through 1 gallon of fuel on the motor stand.
Low needle set without hesitation during transition. ...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.